Vis scale (Slash Command): Difference between revisions

From Homecoming Wiki
Jump to navigation Jump to search
(→‎WARNING!: Tone this down since that warning was written in, er, 2006.)
No edit summary
Line 2: Line 2:
|command=vis_scale
|command=vis_scale
|options=scale
|options=scale
|note=Controls the distance at which objects are rendered and the amount of detailed rendered.
|note=Controls the distance at which objects are rendered and the amount of details rendered.


The user interface, under Options, Graphics and Audio, allows this to be changed via a slider. The slider goes from 50% (0.5) and 200% (2.0). The '''/vis_scale''' command allows you to increase the scale up to 400% (4.0).
The user interface, under Options, Graphics and Audio, allows this to be changed via a slider. The slider goes from 50% (0.5) and 200% (2.0). The '''/vis_scale''' command allows you to increase the scale up to 400% (4.0).

Revision as of 18:51, 16 September 2020

/vis_scale scale

Controls the distance at which objects are rendered and the amount of details rendered.

The user interface, under Options, Graphics and Audio, allows this to be changed via a slider. The slider goes from 50% (0.5) and 200% (2.0). The /vis_scale command allows you to increase the scale up to 400% (4.0).

Any scale higher than 4.0 is rendered as 4.0, and any number lower than 0.5 is rendered as 0.5.

Warning

Setting /vis_scale to 4.0 may not be wise on older hardware. Setting vis_scale to 3 or higher renders almost every object in the zone at once. Your frame rate may be very low and this can make it tricky to reduce vis_scale again.